Galaxy Dx98VHP Galaxy Dx 98 VHP

Home > Communication Electronics >

Our Price: $799.00

Quantity in Stock:(Out of Stock)

Product Code: DX98VHP

Qty:

Description

200 watt maximum power output (PEP)
50 watts more than our DX95T2
After Tune-up :
Variable AM = 6W - 60W peak power 260W
SSB PEP = 200W
Power cord using an quick disconnect,
8 gauge wire and an AGU gold plated 50 amp fuse
New larger bottom heat sink with two internal fans
Blue LEDs for frequency and channel readouts
Blue meter lamp on our signature large meter
StarLite faceplate (backlit)
Red modulation LED under the meter
Side mic jack
AM/USB/LSB modes
Variable power output control
Variable receive gain control
Variable dimmer control for LEDs, meter lamp and faceplate lettering
Switch to turn off the frequency digits
Variable Talkback circuit with on/off switch
Echo and Voice Changer with controls on the front panel
Roger Beep with on/off switch
Automatic SWR circuit
Standard clarifier circuit - no on/off switch
Same main PC board as the DX95T2
Shipping weight is 14 lbs.
TWO YEAR GALAXY WARRANTY

GENERAL
Frequency Range 28.315 ~ 28.755 MHz
Emission AM/USB/LSB
Frequency Control Phase-Lock-Loop (PLL) Synthesizer
Frequency Stability 0.001%
Temperature Range -30°C to +50°C
Antenna Impedance 50 Ohms
Antenna Connectors Standard SO-239 type
Input Voltage 13.8V DC
Size 7 7/8" (W) x 3 1/8" (H) x 10 3/4" (D)
Weight 10 lbs.
TRANSMITTER
RF Power Output AM: 10W~50W
USB/LSB: 200W PEP
Current Drain AM: 25 Amps SSB: 40 Amps (BS)
Local testing shows:
AM 5 - 50w carrier: 22 - 44 Amps
SSB 60-220W PEP: 45 - 66 Amps
Spurious Emission -50 dB
Unwanted Sideband -50 dB
Audio Distortion 10%
Frequency Response 300 to 2500Hz
Microphone Dynamic
Clarifier Range Coarse: ± 6.0KHz,
Fine: ± 1.0KHz
RECEIVER
Sensitivity for 10 dB (S+N)/N AM: < 0.5 ìV;
USB/LSB: < 0.25 ìV
Squelch Sensitivity < 0.5 uV
Selectivity -55 dB
Image Rejection -50 dB
AGC Figure of Merit 100 mV for 10dB Change in Audio Output
Audio Power Output 2.5W @ 10% Distortion
Audio Response 300 to 2500 Hz